The tyre pressure warning light means at least one tyre has dropped far enough below its correct pressure for the system to flag it, which usually happens at around 25% underinflation. The symbol is a horseshoe shape with a flat bottom and an exclamation mark in the middle, meant to look like a cross-section of a tyre. A steady light points at pressure. A light that flashes first and then stays on points at a fault in the system itself.
What the light is telling you:
- Steady light: low pressure in one or more tyres
- Flashing then steady: TPMS fault
- Light after cold weather: temperature-related pressure drop
- Light after a tyre change: sensor not relearned
Steady Light or Flashing Light
This is the first thing to check, because the two mean completely different things and need different fixes.
A steady light from the moment you start means the system has measured low pressure. Check and inflate all four tyres, and the light should clear.
A light that flashes before settling to a steady glow means the system cannot read one or more sensors. That is a fault with the TPMS, not with your tyre pressure, and inflating the tyres will not clear it.
People miss this distinction constantly, then spend a week topping up tyres that were never low. Watch what the light does in the first minute after you start the engine.
How Your System Works
There are two types, and which one you have changes what the light can and cannot tell you.
Direct TPMS puts a battery-powered sensor inside each wheel that measures the actual pressure and transmits it to the car. It is accurate, and many cars with it display the pressure of each tyre individually. The sensors need attention whenever tyres are changed.
Indirect TPMS has no pressure sensors at all. It uses the ABS wheel-speed sensors to spot a tyre that is rotating slightly faster than the others, which happens when a tyre loses pressure and its rolling diameter shrinks. Nothing needs replacing, but the system has to be reset after you inflate or change a tyre.
Indirect systems have a blind spot worth knowing about. If all four tyres lose pressure evenly, there is no speed difference to detect, so the light may stay off while every tyre is underinflated. That is why a monthly manual check still matters.
Why the Light Has Come On
Most cases come down to one of six causes.
- A slow puncture, leaking a few PSI over days rather than deflating suddenly.
- A temperature drop, since air contracts as it cools and a cold snap alone can trigger the light.
- Natural pressure loss, which happens to every tyre gradually over months.
- A leaking valve or a corroded valve stem, where the tyre itself is undamaged.
- A damaged wheel rim letting air escape at the bead, often after a pothole.
- A dead sensor battery on a direct system, which shows as a fault rather than a pressure reading.
If it keeps returning after you inflate, the tyre is leaking rather than just low. The causes and how to narrow them down are covered in can a slow puncture be repaired.
What to Do When It Comes On
Nothing here is urgent enough to stop on a motorway hard shoulder, but it should not wait a fortnight either.
- Find somewhere safe to pull over and look at all four tyres. An obviously flat tyre is a different problem from a warning light.
- Check the pressures cold, meaning before you drive or at least two hours after. Driving warms the air and gives a falsely high reading.
- Use the figures on the door pillar or in the handbook, not the number on the tyre sidewall, which is a maximum rather than a recommendation.
- Inflate all four, including the ones that seem fine.
- Drive for a few minutes and see whether the light clears.
- Check again the next morning. A tyre that has dropped again overnight has a leak.
If the tyre is visibly flat rather than just low, do not drive on it. The damage that causes is covered in can you drive on a slow puncture.
Can You Keep Driving?
With a steady light and tyres that are low but holding air, yes, as far as somewhere you can inflate them. Reduce speed and avoid heavy braking in the meantime.
Underinflation is not a cosmetic issue. It lengthens braking distances, makes the steering vague, raises fuel consumption and heats the tyre up, which is what causes blowouts at speed. It also wears the tread unevenly, chewing out the shoulders while leaving the centre intact, which is the reverse of the pattern described in how to fix inner tire wear.
With a flashing light and normal pressures, the car is safe to drive. You have lost the monitoring, not the tyres.
What It Means for Your MOT
TPMS has been part of the MOT since January 2015, and it applies to cars first used on or after 1 January 2012.
A TPMS that is obviously not working, or a warning lamp clearly indicating a system fault, is recorded as a major defect, which is a fail. The guidance is that a vehicle should be rejected where the lamp indicates a fault in the system, not simply because a tyre is low on the day.
So a flashing-then-steady light is worth fixing before the test. A steady light from low pressure is fixed by inflating the tyres in the car park.
Getting It Diagnosed
If inflating all four does not clear it, or the light is flashing, the system needs reading rather than guessing at.
A TPMS tool reads each sensor’s ID, pressure and battery status, which tells you immediately whether you have a leaking tyre, a dead sensor or a sensor that was never relearned after a tyre change. Guessing at this is how people end up replacing a perfectly good tyre.
Where the tyre turns out to be the problem, the repairability rules are set out in when can a puncture be repaired, and what happens during a mobile visit is described in what to expect from mobile tyre fitting.
If the light stays on after you have already inflated everything, that is a specific situation with its own set of causes, covered in why is my tyre pressure light still on after filling tyres.
Frequently Asked Questions
What does the tyre pressure symbol look like?
A horseshoe shape with a flat bottom and an exclamation mark inside it, designed to resemble a cross-section of a tyre. On some cars it is accompanied by the letters TPMS.
At what pressure does the warning light come on?
Typically around 25% below the recommended pressure, though the exact threshold varies by manufacturer. By then the tyre is already well below where it should be.
Can cold weather turn the tyre pressure light on?
Yes. Air contracts as it cools, so a sharp overnight temperature drop can take a borderline tyre below the threshold without any puncture being involved.
Is it safe to drive with the tyre pressure light on?
For a short distance to a place you can inflate, yes, at reduced speed. Driving on a visibly flat tyre damages the sidewall and usually means replacement rather than repair.
Will the light go off by itself?
On a direct system it clears once pressures are correct and the car has been driven briefly. Indirect systems usually need a manual reset after inflating.
Mobile Tyres Services reads the TPMS properly rather than guessing, so you find out whether you are dealing with a slow leak, a flat battery in a sensor or a reset that never happened. We come to you, at home or at work, with the diagnostic tool and the stock in the van.
We also handle puncture repairs and full replacements on the same visit, so a diagnosis does not turn into a second appointment. Call 07448162740 to get it looked at.